Installation Guide
Standard In-House Connection
Loosen the stainless steel clamps, but DO NOT REMOVE the clamps from the coupling.
Slide the PIPECONX Coupling over the ends of the two pipes to be joined.
Tighten the stainless steel clamps to 60 inch-lbs. of torque.
Support the joint and pressure test for leaks before concealing.
Standard In-House Connection
Loosen the stainless steel clamps, but DO NOT REMOVE the clamps from the coupling.
Slide the PIPECONX Coupling over the ends of the two pipes to be joined.
Tighten the stainless steel clamps to 60 inch-lbs. of torque.
Pressure test before covering joint. Be sure to bed and backfill properly.
Note: Maximum test pressure is 4.3 psi.